This printer prints one-sided

Do the following:

Start -> Printers and Faxes -> Add a printer

When "Welcome to the Add Printer Wizard" appears, click on Next >

Select the option "Local printer attached to this computer" and click on Next >
Remark: Yes, for Windows XP this is the correct choice.

Select "Create a new port:", and then
Type of port: "Standard TCP/IP Port"

When "Welcome to the Add Standard TCP/IP Printer Port Wizard" appears, click on Next >

Enter the following information:

Printer Name or IP Address: 128.205.113.103
Port Name: jetdirect2
Then click on Next >
If a Program Control window appears, allow Explorer.EXE to access the Internet.

When the Additional Port Information Required window appears,
highlight the button Device Type Standard, selectHewlett Packard JetDirect

The window, "Completing the Add Standard TCP/IP Printer Port Wizard" should show,

SNMP: No
Protocol: RAW, Port 9100
Device: 128.205.113.103
Port Name: jetdirect2
Adapter Type: Hewlett Packard JetDirect

The "Add Printer Wizard" appears.

Select from the pull-down menus, the Manufacturer Hewlett Packard and the Printer HP Series 2200 PS (MS)

Under Printer Sharing, select Do not share.
Click on Next>

Name your printer "printer2".

Your printer should now be installed, but your system does not yet
know there is an extra print tray
and duplex printing available.

My Computer -> Control Panel -> printing -> printerd
Properties -> Device Settings -> Tray 2 -> Letter
Printing Preferences -> Finishing -> Print on Both Sides (D) -> Long Edge binding

Print a test page.
If program control window appears, allow Microsoft Printer Spooler Service to access the internet.

Note: At the website, http://printer2.math.buffalo.edu hosted by the printer itself, you can see information about

• the tray configuration,
• whether there is paper in the trays,
• the printer configuration.

To access "Administrator Mode", you will need the password hidden under the panel on the right side of the printer.